2.46. TIMESYNC
These log messages refer to the TIMESYNC (Firewall time synchronization events) category.
2.46.1. synced_clock (ID: 03500001)
Default Severity
NOTICE
Log Message
The
clock
at
<oldtime>,
was
off
by
<clockdrift>
second(s)
and
synchronized with <timeserver> to <newtime>
Explanation
The clock has been synchronized with the time server.
Gateway Action
None
Recommended Action
None.
Revision
2
Parameters
oldtime
newtime
clockdrift
timeserver
2.46.2. failure_communicate_with_timeservers (ID:
03500002)
Default Severity
WARNING
Log Message
Communication with the timeserver(s) failed. Clock not updated.
Explanation
The unit failed to establish a connection with the time sync server. The
clock has not been updated.
Gateway Action
clock_not_synced
Recommended Action
Verify that the time sync server is running.
Revision
1
2.46.3. clockdrift_too_high (ID: 03500003)
Default Severity
WARNING
Log Message
According to the timeserver the clock has drifted <clockdrift>
seconds(s) which is NOT in the allowed correction interval
(+/-<interval> seconds)
Explanation
The clock has drifted so much that it is not within the allowed +/-
correction interval. The clock will not be updated.
Gateway Action
clock_not_synced
Recommended Action
If the correction interval is too narrow, it can be changed in the
Advanced Settings section.
2.46. TIMESYNC Chapter 2. Log Message Reference
453
To Next Page
Loading...
