EasyManua.ls Logo

D-Link DFL-260E

D-Link DFL-260E
486 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2.33. REASSEMBLY
These log messages refer to the REASSEMBLY (Events concerning data reassembly) category.
2.33.1. ack_of_not_transmitted_data (ID: 04800002)
Default Severity
INFORMATIONAL
Log Message
TCP segment acknowledges data not yet transmitted
Explanation
A TCP segment that acknowledges data not yet transmitted was
received. The segment will be dropped.
Gateway Action
drop
Recommended Action
None.
Revision
1
Context Parameters
Connection
2.33.2. invalid_tcp_checksum (ID: 04800003)
Default Severity
NOTICE
Log Message
TCP segment with invalid checksum
Explanation
A TCP segment with an invalid checksum was received. The segment
will be dropped.
Gateway Action
drop
Recommended Action
None.
Revision
1
Context Parameters
Connection
2.33.3. mismatching_data_in_overlapping_tcp_segment
(ID: 04800004)
Default Severity
ERROR
Log Message
Overlapping TCP segment containing different data
Explanation
A TCP segment that partly overlaps segments that has been received
earlier was received. The data in the overlapping part is however
different from the data in the segments received earlier. The segment's
data will be replaced so that it is consistent with the earlier received
segments.
Gateway Action
correct the data
Recommended Action
Research the source of this errornous traffic.
2.33. REASSEMBLY Chapter 2. Log Message Reference
383

Table of Contents

Other manuals for D-Link DFL-260E

Related product manuals