2.47. TRANSPARENCY
These log messages refer to the TRANSPARENCY (Events concerning the Transparent Mode
feature) category.
2.47.1. impossible_hw_sender_address (ID: 04400410)
Default Severity
WARNING
Log Message
Impossible hardware sender address 0000:0000:0000. Dropping.
Explanation
Some equipment on the network is sending packets with a source
MAC address of 0000:0000:0000. These packets will be dropped.
Gateway Action
drop
Recommended Action
Investigate if there are equipment sending packets using
0000:0000:0000 as source MAC address. If there are, try to change the
behaviour of that equipment.
Revision
1
Context Parameters
Rule Name
Packet Buffer
2.47.2. enet_hw_sender_broadcast (ID: 04400411)
Default Severity
NOTICE
Log Message
Ethernet hardware sender is a broadcast address. Accepting.
Explanation
The Ethernet hardware sender address is a broadcast address. The
packet will be accepted.
Gateway Action
accept
Recommended Action
None.
Revision
1
Context Parameters
Rule Name
Packet Buffer
2.47.3. enet_hw_sender_broadcast (ID: 04400412)
Default Severity
NOTICE
Log Message
Ethernet hardware sender is a broadcast address. Rewriting to the
address of the forwarding interface.
Explanation
The Ethernet hardware sender address is a broadcast address. The
packet will be rewritten with the hardware sender address of the
forwarding interface.
Gateway Action
rewrite
2.47. TRANSPARENCY Chapter 2. Log Message Reference
455
To Next Page
Loading...
