Daedong DK4520 - Operating the Engine; Starting the Engine

5
5
-
3
OPERATION
1. Make sure there is no obstacle
around the tractor.
2. Make sure the parking brake is set.
OPERATING THE ENGINE
STARTING THE ENGINE
111
A
B
A
B
D21O501A
(1) Parking Brake Lever
(A) Depress (B) Pull
IMPORTANT
• Using ether or starting uid so
the engine will start more easily
can damage the engine. And it
will not be covered by warranty.
• Never try to start the engine for
over 10 seconds consecutively
to protect the start motor and
battery from damage.
IMPORTANT
Safety start system is applied:
• Start condition (HST): Operator
on the seat + Pushing brake
pedal. (HST pedal, Rear PTO
and Mid PTO levers should be
in neutral position)
• Start condition (Mechanical):
Operator on the seat + Applying
clutch pedal + Pushing brake
pedal. (Shuttle lever, Rear PTO
and Mid PTO levers should be in
neutral position)
• Operation continuance condi-
tion when operator leaves from
the seat: when parking brake in
on and range shift and Mid PTO
lever is in a neutral position. In
any other condition, the tractor
stops operation by it self in 3 sec
of time delay.
IMPORTANT
• Make sure that the brake pedals
are fully depressed before pull-
ing the parking brake lever up.
WARNING
To avoid accidents:
• Be sure to read and understand
the warning and caution decals
on the tractor thoroughly.
• Run the engine only in a
well-ventilated area, or you can
be su󰀨ocated by exhaust gas.
• Never start the engine unless
you are on the driver’s seat. The
tractor can abruptly start o󰀨, re-
sulting in an injury or accident.
OM_TD220(DK4220,4520,4720,5020,5320,5520,6020)-EN(USA)_05.indd 3OM_TD220(DK4220,4520,4720,5020,5320,5520,6020)-EN(USA)_05.indd 3 2023-09-22 오전 11:35:542023-09-22 오전 11:35:54