Daedong DK4520 - Checking Gauges, Meter and Indicators; Checking Gauges, Meter and Indi- Cators; Checking Head Light, Hazard Light Etc; Checking Seat Belt and Cabin

58
8
-
17
MAINTENANCE
1. Inspect the instrument panel for
broken gauge(s), meter(s) and in-
dicators.
2. Replace if broken.
CHECKING HEAD LIGHT, HAZ-
ARD LIGHT ETC.
1. Inspect the lights for broken bulbs
and lenses.
2. Replace if broken.
CHECKING SEAT BELT AND
CABIN
1. Always check the condition of the
seat belt and cabin before operating
tractor.
2. Replace if damaged.
CHECKING GAUGES, METER
AND INDICATORS
3. To drain the used fluid, place the
oil container under the transmis-
sion case and remove the drain
plug to drain used uid.
If the uid does not ow out freely,
unscrew the breather plug on the
side of the hydraulic cylinder on
the left of the top link bracket to
facilitate drainage. (Refer to next
page) Reinstall the drain plugs se-
curely afterward.
(1) Drain Plug
1
1
11
1
1
11
REPLACING TRANSMISSION FLUID AND FILTER
If transmission uid is contaminated
or the transmission is repaired, trans-
mission fluid should be changed.
Make sure to replace its lter as well.
However, Replace the oil lter only at
every 200 hours of operation.
1. Park the tractor on a level ground
and start the engine to warm it up.
2. Stop the engine, apply the parking
brake and remove the drain plug.
(1) Hydraulic Filter
D21O705A
D21O706A
OM_TD220(DK4220,4520,4720,5020,5320,5520,6020)-EN(USA)_08.indd 17OM_TD220(DK4220,4520,4720,5020,5320,5520,6020)-EN(USA)_08.indd 17 2023-09-22 오전 11:36:152023-09-22 오전 11:36:15