Daedong DK4520 - Page 201

58
8
-
31
MAINTENANCE
(1) Engine Oil Filter
5. Remove the oil lter from the bot-
tom of the fuel filter on the right
side of the engine.
6. Apply a thin lm of oil to the O-ring
of a new lter and tighten the new
lter rmly by hand.
7. Fill the engine oil to the specied
level and tighten the oil lter to the
specied torque.
TD2O711A
Oil Capacity [U.S. gal(L)]
1.95 (7.4)
8. Run the start motor for approx.
10 seconds to distribute oil to
each part of the engine.
9. Run the engine for approx. 5 min-
utes and check for proper opera-
tion through the engine oil warning
lamp. Then, stop the engine. (It is
normal that the oil warning lamp is
o󰀨 while the engine running)
10. Check the engine oil level again
with the oil dipstick. If the level is
low, add more oil.
NOTE
• The engine oil filter should be
replaced when changing the en-
gine oil.
WARNING
• The engine oil is very hot while
the engine is running or right
after the engine is stopped. Be
careful not to be burnt.
• Avoid oil contact while chang-
ing or adding engine oil and
wear eye protection to prevent
eye contact.
• Prolonged and repeated contact
with the engine oil may cause
skin disorders and skin cancer.
If skin contact is made, wash
thoroughly with soap or hand
cleaner as soon as possible.
• Keep the used oil out of reach
of children.
OM_TD220(DK4220,4520,4720,5020,5320,5520,6020)-EN(USA)_08.indd 31OM_TD220(DK4220,4520,4720,5020,5320,5520,6020)-EN(USA)_08.indd 31 2023-09-22 오전 11:36:172023-09-22 오전 11:36:17