15-4
Hydraulic Brake
If the brake bleeder is not available, use the
following procedure.
Fill the master cylinder reservoir to the upper
level mark. Connect the bleeder hose to the
bleed valve and bleed the system as follows.
1. Squeeze the brake lever, open the bleed valve
1/2 turn and then close the bleed valve.
• Do not release the brake lever until the bleed
valve has been closed.
2. Release the brake lever slowly and wait several
seconds after it reaches the end of its travel.
3. Repeat step 1 and 2 until air bubbles cease to
appear in the fluid coming out of the bleed
valve.
Check the fluid level often. Add fluid when
the fluid level in the master cylinder reservoir
is low.
Do not release the brake lever until the bleed
valve has been closed.
Tighten the bleed valve.
Torque: 0.6kgf-m
Fill the master cylinder reservoir to the upper
level mark with brake fluid. Install the
diaphragm, set the master cylinder cap.
Torque: 0.13kgf-m
Brake Pad
Replacement
• Always replace the brake pads in pairs to
assure even disc pressure.
• Replace the brake pads without removing
brake hose.
Loosen the caliper braket bolt installed to L.
front fork.
Bleed Valve
Bleed Valve
Bleed Valve
Bleed Valve
Bleed Valve
Bleed ValveBleed Valve
Bleed Valve
Bleed Valve
Bleed Valve
Bleed Valve
Bleed Valve
Bleed Valve
Master Cylinder
Master Cylinder
Master Cylinder
Master Cylinder
Master Cylinder
Master CylinderMaster Cylinder
Master Cylinder
Master Cylinder
Master Cylinder
Master Cylinder
Master Cylinder
Master Cylinder
Brake Hose
Brake Hose
Brake Hose
Brake Hose
Brake Hose
Brake HoseBrake Hose
Brake Hose
Brake Hose
Brake Hose
Brake Hose
Brake Hose
Brake Hose
”UP” Mark
”UP” Mark
”UP” Mark
”UP” Mark
”UP” Mark
”UP” Mark”UP” Mark
”UP” Mark
”UP” Mark
”UP” Mark
”UP” Mark
”UP” Mark
”UP” Mark
Braket Bolt
Braket Bolt
Braket Bolt
Braket Bolt
Braket Bolt
Braket BoltBraket Bolt
Braket Bolt
Braket Bolt
Braket Bolt
Braket Bolt
Braket Bolt
Braket Bolt
NOTE
NOTE
To Next Page
Loading...
Need help?
General
