14-8
Rear Wheel/Rear Brake/Suspension
Rear Brake Pedal
Disassembly
● Remove the bolts and brake pedal.
● Loosen the rear brake adjusting nut and
remove the brake rod from the brake arm.
● Separate the stop switch spring from the return
spring.
● Tilt the motorcycle body to the left, remove the
pedal pivot shaft by pushing.
Assembly
● Apply grease to the brake pedal pivot shaft and
install it while hooking the stop switch spring
and brake return spring.
● Install the brake pedal bolt, aligning the punch
mark on the brake pedal with the punch mark
on the pivot shaft. Install the brake pedal bolt.
Torque: 2.2kgf-m(22N.m)
● Adjust the rear brake free play.
Free play: 20~30mm
Rear Cushion (Shock Absorber)
Removal
● Raise and support the motorcycle with main
stand.
●
Loosen the rear cushion upper, lower mounting
bolts, remove the rear cushion.
20~30mm
20~30mm
20~30mm
20~30mm
20~30mm
20~30mm20~30mm
20~30mm
20~30mm
20~30mm
20~30mm
20~30mm
20~30mm
Stopper Bolt
Stopper Bolt
Stopper Bolt
Stopper Bolt
Stopper Bolt
Stopper BoltStopper Bolt
Stopper Bolt
Stopper Bolt
Stopper Bolt
Stopper Bolt
Stopper Bolt
Stopper Bolt
Stopper Switch Spring
Stopper Switch Spring
Stopper Switch Spring
Stopper Switch Spring
Stopper Switch Spring
Stopper Switch SpringStopper Switch Spring
Stopper Switch Spring
Stopper Switch Spring
Stopper Switch Spring
Stopper Switch Spring
Stopper Switch Spring
Stopper Switch Spring
Lower Flange Bolt
Lower Flange Bolt
Lower Flange Bolt
Lower Flange Bolt
Lower Flange Bolt
Lower Flange BoltLower Flange Bolt
Lower Flange Bolt
Lower Flange Bolt
Lower Flange Bolt
Lower Flange Bolt
Lower Flange Bolt
Lower Flange Bolt
Upper Flange Bolt
Upper Flange Bolt
Upper Flange Bolt
Upper Flange Bolt
Upper Flange Bolt
Upper Flange BoltUpper Flange Bolt
Upper Flange Bolt
Upper Flange Bolt
Upper Flange Bolt
Upper Flange Bolt
Upper Flange Bolt
Upper Flange Bolt
To Next Page
Loading...
Need help?
General
