Web Interface 62
The time amount for which the lock stays open after unlock, and
the unit is second.
Check Door Sensor
Signal Before Lock
Select the Check Door Sensor Signal Before Lock check box to
enable alarm function, and If the unlock time exceeds the Door
Sensor Check Time, the door sensor alarm is triggered, and the
alarm will be sent to the management center.
You can connect a third-party phone such as SIP phone to your
VTO, and use the command to open the door remotely.
This password can be used to issue new card.
This password is only for admin people or engineer.
It is 002236 by default.
It can be used to go to the engineering interface, and it is 888888
by default.
Project password is only for admin people or engineers.
Select Lift Control Protocol and Lift Control Enable to enable
the lift control function, and then you can configure the floors that
lift users can go to.
Enter the baud rate of the third party 485 device that you need.
Select Common Password Enable, then configure unlock
password, and then all the residents in this unit can open the door
with this password.
New Unlock
Password Confirm
Select Menace Password Enable to configure duress password
function.
Once the duress password is used, the alarm is triggered, and it
will be sent to the management center.
New Menace
Password Confirm
Select Turn on, and then the system takes 2 snapshots when
unlocking, and then upload to the FTP.
Click OK to save.
Step 3
7.3.3 Talk Manager
Upload the snapshots and the video and audio messages to the FTP. Make sure the FTP is
properly configured.
This section introduces how to configure auto snapshot and how to leave messages during
phone call.
To Next Page
Loading...
Need help?
General
