Dahua DH-VTO9341D User Manual

Web Interface 84
Table 7-16 IPC parameter description
Parameter
Description
IPC Name
The name of the IPC/NVR/XVR/HCVR.
IP
Address
The IP address of the IPC/NVR/XVR/HCVR.
Username
The username and password for the Web interface of the
IPC/NVR/XVR/HCVR.
Password
Port
It is 554 by default.
Protocol
Select from Local and Onvif, you can select according to the device
you want to connect to the VTO..
Stream
Select Main Format or Extra Format as needed.
Main Format: It has large bit rate value and image with high

resolution, but also requires large bandwidth.
Extra Format: It has small bit rate value and smooth image, and

requires little bandwidth. This option is normally used to replace
main stream when bandwidth is not enough.
Channel
It you connect IPC to the VTO, the value is 1 by default.

It you connect NVR/XVR/HCVR to the VTO, configure the value to

the channel number of the IPC on the NVR/XVR/HCVR.
Click OK to finish configuration. Step 3
7.10.3 Import Config
You can import IPC Information from local storage to the VTO.
Click Import Config, and then the File Upload interface is displayed.
Step 1
Click File, then select the .csv file you need,. Step 2
Click Upload. Step 3
Enter the password for the Web interface, and then click OK. Step 4
7.10.4 Export Config
You can export the IPC information from the VTO to the local storage for future use.
Click Import Config.
Enter the password for the Web interface.
Publish Information 7.11
This function is displayed only when the VTO you are visiting works as SIP server.
If the VTO you are visiting works as SIP server, you can publish information to the VTH users,
and you can view the publish history in System Config > Publish Information > History Info.

Dahua DH-VTO9341D Specifications

General

Brand	Dahua
Model	DH-VTO9341D
Category	Intercom System
Language	English