Web Interface 75
Click OK to save.
Step 2
The VTO reboots, and then the login interface is displayed.
7.6.4 Port Config
Configure the port that is used to login the VTO Web interface.
Select System Config > Network Config > Port Config. Step 1
The Port Config interface is displayed. See Figure 7-25.
Port Config Figure 7-25
Web Port Step 2
It is 80 by default, if it is occupied, you can use numbers from 1025 to 65535.
Click OK to save. Step 3
If the port is changed, enter "http://VTO IP address: web port" in the address bar of the
Internet browser to login the Web interface of the corresponding VTO.
7.6.5 DDNS Config
Properly configure DDNS, and then you can always visit your VTO with a constant domain
name no matter how much your VTO IP address changes.
Before start, check whether your VTO supports the servers in Server Type, and then go to
the DDNS website and register the username, password, and domain name.
Finish register, then log in the DDNS website, and then you can view all the connected
devices in your account.
Select System Config > Network Config > DDNS Config. Step 1
The DDNS Config interface is displayed. See Figure 7-26.
To Next Page
Loading...
Need help?
General
