Dahua DH-VTO9341D - 7.6.3 SIP Server Config

Web Interface 74
7.6.3 SIP Server Config
Select System Config > Network Config > SIP Server Config, and then the SIP Server
Config interface is displayed. See Figure 7-24.
SIP server configuration Figure 7-24
 If the VTO you are visiting works as SIP server
Select SIP Server Enable, and then click OK. The VTO reboots, and then the login
interface is displayed.
 If other VTO works as SIP server
Configure parameters. See Table 7-11 for the details. Step 1
Table 7-11 SIP server config (1)
Parameter
Description
IP Address
The IP address of the VTO that works as SIP server.
Port
It is 5060 by default.
Username
Leave to the default.
Password
SIP Domain
The SIP Domain is VDP.
Username
The username and password of the SIP server.
Password
Click OK to save. Step 2
The VTO reboots, and then the login interface is displayed.
 If third party server works as SIP server
Configure parameters. See Table 7-12 for the details. Step 1
Table 7-12 SIP server config (2)
Parameter
Description
IP Address
The IP address of the server that works as SIP server.
Port
5080
Username
Leave to the default.
Password
SIP Domain
Leave it blank or keep the default..
Username
The username and password of the SIP server.