User’s Manual EM11A015B
intelligent Touch Manager
103
(7) Setpoint Restriction setup eld
Sets up the setpoint restriction.
Respectively enable or disable the setpoint restrictions for cooling and heating using the combo
boxes.
Touch the respective Modify buttons and enter the maximum and minimum values in the
Numerical Input dialog that appears.
The range of values you can enter is the same as that for the Setpoint (2) but the entered values
should be such that they do not invert the upper and lower limits.
•
The Setpoint Restriction does not apply to the following items;
AHU, Hydrobox: leaving water setpoint and storage setpoint, Inv.Chiller: leaving water setpoint,
and Chiller: leaving water setpoint.
NOTE
(8) OK button
Saves the edit and closes the screen.
(9) Cancel button
Cancels the edit and closes the screen.
To Next Page
Loading...
