User’s Manual EM11A015B
intelligent Touch Manager
289
2. Touch the Common tab (3) of the Detailed Setup screen and display the Common screen.
Select the Filter Sign Reset check box (4) to enable the reset. Touch the OK button and close
the screen.
Not selectable when there are no lter signs.
NOTE
13-2 Maintaining the LCD display
When the surface of the LCD of the iTM or the iTM unit is dirty, wipe the dirt off with a piece of soft
cloth soaked in a diluted neutral detergent and wrung sufciently.
• Do not use strongly acid detergent and organic solvents such as alcohol, paint thinner, or
benzine. The print may fade, or wear out and discolor.
• Forcibly rubbing with hard cloth may damage the LCD display. Always use soft cloth to
remove dirt.
• Leaving the LCD display with water droplets and/or dirt may stain the LCD or peel off the
coating.
CAUTION
To Next Page
Loading...
