Daikin DCM601A52 - Page 6

Safety Precautions
User’s Manual EM11A015B
intelligent Touch Manager
5
CAUTION
• Do not touch the air inlet or aluminium ns of the outdoor unit.
Doing so may result in injury.
• Do not place objects that are susceptible to moisture directly beneath the indoor
or outdoor unit.
Under certain conditions, condensation on the main unit or refrigerant pipes, air lter dirt or
drain blockage may cause dripping, resulting in fouling or failure of the object concerned.
• Do not place appliances that produce naked ames in places exposed to the
airow from the unit.
Doing so may impair combustion of the burner.
• Do not place heaters directly below or near the indoor unit.
The resulting heat can cause deformation of the inlet grille.
• Be sure that children, plants, or animals are not exposed directly to airow from
the unit, as adverse effects may ensue.
• Do not put ammable containers, such as spray cans, within 1 m from the air
outlet.
The containers may explode because the warm airow from the indoor or outdoor unit will
affect them.
• Do not touch the motor parts at the time of lter replacement.
The motor in operation is at high temperature and may cause burn.
• Turn off the main power switch when the air conditioner is not to be used for
prolonged periods.
When the main power switch is left on, some electrical power (watts) is still consumed even if
the air conditioner is not operating. Therefore, switch off the main power switch to save energy.
When resuming operation, to ensure smooth running, turn on the main power switch 6 hours
before operating the air conditioner again.
• Do not install the air conditioner at any place where there is a danger of amma-
ble gas leakage.
In the event of a gas leakage, build-up of gas near the air conditioner may result in re.
• Do not sit or stand on any unstable base at the time of operating or maintaining
the air conditioner.
The base may topple and this can result in injury.
• Do not operate with the control panel lid open.
If water gets inside the panel, it may result in equipment failure or electric shock.