Figure 73. Installing the expansion card riser 1
Next steps
1 If removed, install the expansion cards into the riser.
2 Follow the procedure listed in After working inside your system.
3 Install any device drivers required for the card as described in the documentation for the card.
Identifier GUID-936FF1EB-7C0A-4315-B800-CC62D82B27E6
Status Released
Removing the expansion card riser 2
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If applicable, close the PCIe card holder latch on the air shroud to release the full length card.
4 If installed, remove the expansion cards from the riser.
5 Remove the air shroud.
6 Disconnect any cables connected to the riser.
Step
To remove expansion card riser 2B, hold the riser by its edges and lift the riser from the riser connector on the system board.
Installing and removing system components
125
To Next Page
Loading...
