Dell EMC NX3240 - System Battery; Replacing the System Battery

Figure 95. Cable routing – 4 x 3.5 mid backplane with 12 x 3.5-inch backplane
1
backplane 2 SAS cable (BP: BP: A1 BP SAS to mid BP: J_SAS_A1,
J_SAS_B1)
3 mid backplane 4 mid backplane signal cable (Mid BP: J_BP_SIG to MB)
5 mid backplane power cable (Mid BP: J_BP_PWR to MB)
Identifier GUID-E6FDE17E-040B-44A4-BBEE-0C1D53AEF88B
Status Released
System battery
The system battery is used for low-level system functions such as powering the real-time and date settings of the system.
This section contains information about replacing the system battery.
Identifier GUID-3CD7DC6E-73CA-4B56-AAC9-49B7DDD6102E
Status Released
Replacing the system battery
Prerequisites
WARNING
: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. For more information, see the safety information that shipped with your
system.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Installing and removing system components
143