Figure 35. Removing a 3.5-inch drive from the drive carrier
Next step
Install a 3.5-inch drive into the drive carrier.
Identifier GUID-94B85F8B-FB33-4263-9400-724C1DA8BB01
Status Released
Installing a 3.5-inch drive into the drive carrier
Prerequisite
Follow the safety guidelines listed in Safety instructions.
CAUTION
: Mixing drives from previous generations of NAS systems is not supported.
Steps
1 Align the tabs on the drive carrier with the slots on the drive.
2 Pull the edges of the carrier to t over the drive.
3 Lower the drive carrier onto the drive to secure it.
Installing and removing system components
87
To Next Page
Loading...
