Dell EMC NX3240 - Network Daughter Card; Removing the Network Daughter Card

Figure 75. Installing the expansion card riser 2
Next steps
1 Install the air shroud.
2 If removed, install the expansion cards into the riser.
3 If applicable, open the PCIe card holder latch on the air shroud to install the full length card.
4 Follow the procedure listed in After working inside your system.
5 Install any device drivers required for the card as described in the documentation for the card.
Identifier GUID-924E9B67-3E96-44F4-8181-9FDD5E3A7128
Status Released
Network daughter card
The network daughter card (NDC) is a small, removable mezzanine card, which provides the exibility of selecting dierent network
connectivity options.
This section contains information about the removal and installation of the network daughter card.
Identifier GUID-D0206B70-CA05-4F2A-B783-A06F3FB298AF
Status Released
Removing the network daughter card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the expansion card riser 2 or the rear drive cage, depending on the conguration of your system.
Installing and removing system components
127