Dell EMC NX3240 - Installing the MID Drive Tray

Steps
1 Lift the drive tray handles 90 degrees upward.
2 Hold the drive tray handles, and lift the drive tray out of the system.
Figure 29. Removing the mid drive tray
NOTE
: The images shown here are for representation only and the actual conguration of your system may vary.
Next step
Install the mid drive tray.
Identifier GUID-953734ED-90E8-4DEA-817D-A0AA153775E6
Status Released
Installing the mid drive tray
Prerequisite
1 Follow the safety guidelines listed in Safety instructions.
NOTE
: Systems that support the internal drive tray support low-prole heat sinks and do not support an air shroud.
Steps
1 Lift the drive tray handles to 90 degrees upward.
2 Hold the drive tray handles, and align the slots on the drive tray with the guide pins on the system.
3 Lower the drive tray into the system.
4 Lower the drive tray handles to lock the drive tray in place.
Installing and removing system components
81