Figure 47. Removing a 2 x 3.5-inch drive rear cage
Next step
Install the rear drive cage.
Identifier GUID-02845C89-A556-4465-A9A6-4E6D47F6ED89
Status Released
Installing a rear drive cage
The procedure for installing 2.5-inch and 3.5-inch rear drive cages is identical.
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Align the screws on the drive cage with the screw holes on the system.
2 Lower the drive cage into the system until it is rmly seated.
3 Using Phillips #2 screwdriver, tighten the screws to secure the drive cage to the system.
Installing and removing system components
99
To Next Page
Loading...
