Calling a Stored Program
183
Calling a Stored Program
The following describes how to call a stored program.
When you call a specified stored program, the last screen shown when you registered the
stored program appears.
1
Press the <Home> button.
2
Select [Stored Programming].
3
Select a number of a stored program containing
the features you want to use.
Note • You can only select registered numbers.
• Select [ ] to return to the previous screen or
[ ] to move to the next screen.
• After the stored program has been called, the
machine sounds an audible tone. If a failure
occurs, the machine sounds a fault tone.
For information on how to change the volume of the
sound that notifies that a stored program has been
called, refer to "Stored Programming Complete
Tone" (P.319).
4
After the stored program is called, select other
features if necessary.
5
Press the <Start> button.
To Next Page
Loading...
