23 Problem Solving
692
Stapler Faults
This section describes how to clear stapler troubles when the optional finisher is installed.
Perform the procedures on the following pages when copies are not stapled or staples are
bent. Contact Customer Support at dell.com/contactdell if the problem persists after you
have tried the following solutions.
If copies are stapled as shown in the figures below, contact Customer Support at
dell.com/contactdell.
One side of staple rising up Staple bent in reverse direction
Flattened staple Entire staple rising up
Staple rising up with center pressed in
To Next Page
Loading...
