28 Using Shortcut Menu
754
Checking Your Environment
This section describes several settings that must be set by system administrator to use
Shortcut Menu feature. Check the proper settings below before you enable Shortcut Menu
feature.
Port Settings
• [Port Status] is set to [Enabled] in [SOAP] under [System Settings] > [Connectivity &
Network Setup] > [Port Settings].
• [Port Number] is set to [80] in [SOAP] under [System Settings] > [Connectivity &
Network Setup] > [Port Settings].
Protocol Settings
• IP address, subnet mask, and gateway address (i.e. settings for the use in TCP/IP network
environment) are set in [Protocol Settings] under [System Settings] > [Connectivity &
Network Setup].
Web Browser Setup
• [V4 (New Version)] is set in [Web Applications Version] under [System Settings] >
[Web Browser Setup].
Authentication Settings
• [Login to Local Accounts] or [Login to Remote Accounts] is set in [Login Type] under
[Authentication / Security Settings] > [Authentication].
• Shortcut Menu users are registered on the machine.
Access Control
• [Device Access] is set to [Locked] in [Access Control] under [Authentication / Security
Settings] > [Authentication].
Screen Default
• To show the Shortcut Menu screen after authentication: [Shortcut Menu] is set in
[Screen Default] under [System Settings] > [Common Service Settings] > [Screen /
Button Settings].
• To show the [Home] screen after authentication: [Home] is set in [Screen Default] under
[System Settings] > [Common Service Settings] > [Screen / Button Settings].
To Next Page
Loading...
