Web Applications Service Setup
417
Server Setup
This section describes how to register a server on access web applications.
Note • If there are one or more servers to register, it is helpful to assign the servers to the buttons displayed
on the [Home] screen.
1
Select [Server Setup].
2
Select an access destination you want to register, and then select [Change Settings].
3
Enter the URL of the access destination, if you register an access destination in a new entry.
URL
Enter the URL of the access destination with up to 256 single-byte characters, and select
[Save]. URL must begin with the type of the protocol used.
Use the version of a web application that is set [Web Applications Version] in "Web Browser
Setup" (P.419).
For example:
• http://www.example.com
• http://192.0.2.1 (IPv4)
• http://[2001:DB8::1234] (IPv6)
• https://www.example.com
• https://192.0.2.1 (IPv4)
• https://[2001:DB8::1234] (IPv6)
• When specified with V2 (old version)
- http-v2://www.example.com
- http-v2://192.0.2.1 (IPv4)
- http-v2://[2001:DB8::1234] (IPv6)
• When specified with V3
- http-v3://www.example.com
- http-v3://192.0.2.1(IPv4)
- http-v3://[2001:DB8::1234] (IPv6)
• When specified with V4 (new version)
- http-v4://www.example.com
- http-v4://192.0.2.1 (IPv4)
- http-v4://[2001:DB8::1234] (IPv6)
Note • When the URL is specified with V3, V4 (new version) is used for connection.
• Begin with "https" for a protocol with an encryption feature.
4
Configure other settings as necessary.
Server Name
Enter the access destination name with up to 32 single-byte characters.
Description
Enter the description of the access destination with up to 128 single-byte characters.
To Next Page
Loading...
Need help?
General