15 Tools
334
Select the notification timing from [Notify at the End of Job] or [Notify when Error Only].
E-mail Addresses 1 to 5
Specify the e-mail addresses to notify the result of the jobs.
Note • When you select [Save] to exit this screen without specifying an e-mail address, the setting of
[Targeted Jobs] or [E-mail Message] is deleted.
E-mail Message
Enter a comment attached to the e-mail.
Plug-in Settings
When you use custom services, you can set whether to enable embedded plug-ins and display
the list of the plug-ins.
Embedded Plug-ins
Set whether to enable embedded plug-ins.
List of Embedded Plug-ins
Displays [Name] and [Status] of embedded plug-ins.
Other Settings
You can configure other settings related to the machine.
Offset Stacking (Center Tray)
Offsetting means that each set of copies is delivered to the center tray and shifted slightly to
separate it from the previous job. When a set of copies is delivered to the front of the tray,
the next set is delivered to the rear of the tray. Set the offset function for the Center Tray.
Select from [No Offset], [Offset per Set], and [Offset per Job]. When [Offset per Set] or
[Offset per Job] is selected, the machine slightly shifts the output position per set or per job
(print job) respectively.
Offset Stacking (Center Tray - Upper)
Offsetting means that each set of copies is delivered to the center tray and shifted slightly to
separate it from the previous job. When a set of copies is delivered to the front of the tray,
the next set is delivered to the rear of the tray. Set the offset function for the Center Tray -
Upper. Select from [No Offset], [Offset per Set], and [Offset per Job]. When [Offset per
Set] or [Offset per Job] is selected, the machine slightly shifts the output position per set or
per job (print job) respectively.
Offset Stacking (Center Tray - Lower)
Offsetting means that each set of copies is delivered to the center tray and shifted slightly to
separate it from the previous job. When a set of copies is delivered to the front of the tray,
the next set is delivered to the rear of the tray. Set the offset function for the Center Tray -
Lower. Select from [No Offset], [Offset per Set], and [Offset per Job]. When [Offset per
Set] or [Offset per Job] is selected, the machine slightly shifts the output position per set or
per job (print job) respectively.
To Next Page
Loading...
Need help?
General