Cleaning the Machine
261
3
Lower the cover.
Note • You can now see the drum cartridge.
4
Slowly slide out the cleaning bar housed within
the LED printhead until it stops. The cleaning
bars are located in the cleaning connection just
under the drum cartridges R1, R2, R3, and R4.
Note • Slide out the cleaning bar until you see
"zzz".
• Do not remove the cleaning bar from the
housing.
5
Slowly slide the cleaning bar back into place.
Note • Clean the four LED printheads R1 to R4 by
sliding the cleaning bar back and forth for two
or three times respectively.
6
Return the cover to the original position.
Note • Push the cover until it clicks into place.
7
Rotate the release lever clockwise to lock the
cover.
8
Close the front cover.
Note • If the front cover is not closed completely, a message appears and the machine will remain paused.
To Next Page
Loading...
Need help?
General