To Next Page

To Previous Page

Print Service Settings

381

Receiving Buffer - USB

Set the receiving buffer for USB.

You can specify a value from 64 to 1024 KB in 32 KB increments.

Receiving Buffer - LPD

Note • You may not be able to change the [Receiving Buffer - LPD] setting because of the setting of [LPD Print

Queue].

For more information on [LPD Print Queue], refer to "LPD Print Queue" (P.386).

No Spooling

Does not use spooling. While LPD printing is performed for one client, data cannot be

received over the same interface from another client.

Specify a value for the dedicated LPD receiving buffer memory capacity from 1024 to 2048

KB in 32 KB increments.

Spool to Memory

Carries out spooling. The receiving buffer for spooling uses memory. When this setting is

selected, specify the memory capacity of a receiving buffer for spooling from 0.50 MB to

32.00 MB in 0.25 MB increments.

Note that print data exceeding the memory capacity set is not accepted. In such cases, select

[Spool to Hard Disk] or [No Spooling].

Spool to Hard Disk

Carries out spooling. The receiving buffer for spooling uses the hard disk.

Receiving Buffer - NetWare

Set the NetWare receiving buffer.

Specify a value from 64 to 1024 KB in 32 KB increments.

Receiving Buffer - SMB

No Spooling

Does not use spooling. While SMB printing is performed for one client, data cannot be

received over the same interface from another client.

Specify a value for the dedicated SMB receiving buffer memory capacity from 64 to 1024 KB

in 32 KB increments.

Note • If you select [No Spooling], job names are displayed as "unknown document name".