Status Code
647
026-708
[Cause] Exceeded the maximum limit for the scan data size that can be stored for one job with
Store & Send Link.
[Remedy] Take one of the following measures:
1)Reduce the resolution (scan quality) of the scan parameters and execute the operation
again.
2)Reduce the image with magnification of the scan parameters (such as A3 > A4) and
then execute the operation again.
3)If [Store & Send Link - Maximum File Size] is set to a small value, increase the value.
026-709
[Cause] The capacity of the hard disk that can be used to store scan data with Store & Send Link
is insufficient.
[Remedy] Wait around one day, and when capacity becomes available as a result of the automatic
deletion of files, execute the operation again.
026-710
[Cause] The machine has received an e-mail encrypted by S/MIME, but does not support the
encryption method.
[Remedy] Take one of the following measures:
• Ask the sender to send the e-mail encrypted by 3DES.
• Disable the FIPS140 validation mode of the machine.
026-711
[Cause] Exceeded the maximum size allowed for a multi-page file when scanning.
[Remedy] Take one of the following measures:
1)Reduce the resolution (scan quality) of the scan parameters and execute the operation
again.
2)Reduce the number of document pages and then execute the operation again.
The maximum size is 2 GB for TIFF, XPS, and PDF.
Note • XPS stands for XML Paper Specification.
026-712
[Cause] An error occurred while operating from Dell Printer Configuration Web Tool.
[Remedy] Retry after waiting for a while.
026-718
[Cause] Incompatible print parameters are used. The combination of the specified features such
as Document Size, Paper Size, Paper Tray, 2 sided printing, and Output Tray is
incompatible.
[Remedy] Confirm the print data, and try printing again.
026-719
[Cause] An error occurred while operating the Store to USB service.
[Remedy] Wait for a while and execute the operation again. If the error still is not resolved, contact
Customer Support at dell.com/contactdell.
026-720
[Cause] The capacity of the USB memory device of the recipient is insufficient while performing
the Store to USB service.
[Remedy] Confirm the amount of available space.
026-721
[Cause] An error occurred while operating the Store to USB service.
[Remedy] Check the following conditions:
• The USB memory device is inserted into the USB memory slot.
• The USB memory device is accessible from your computer.
• The unencrypted USB memory device is used.
Status Code Cause and Remedy
To Next Page
