Dell EMC ML3 User Manual

Table 32. Default settings (continued)
Parameter Default
Configuration
Reset Default
Settings
Password rules Min. number of characters
Min. number of uppercase alphabetic characters
Min. number of lowercase alphabetic characters
Min. number of numeric characters
Min. number of special characters
Max. number of identical consecutive characters
Max. number of failed logins
Max. number of days before PW must be changed
Number of PW changes before it can be used again
8
1
1
1
0
2
3
90
3
x
Management GUI Restricted
Login
Disabled x
Allow I/O Station/Magazine
access by "user" monitor account
Disabled x
Session Locking Disabled x
Remote Authentication (LDAP)
Configuration
Disabled NOT reset
Network configuration (eth0)
Host name Blank NOT reset
IP address (dhcp) NOT reset
Subnet mask (dhcp) NOT reset
Default gateway (dhcp) NOT reset
Auto Negotiate Enabled NOT reset
Speed Auto NOT reset
IPv4 Enabled NOT reset
DHCPv4 Enabled NOT reset
IPv6 NOT reset
IPv6 Prefix Enabled NOT reset
Static v6 Disabled NOT reset
IPv6 Method Disabled NOT reset
DHCPv6 Disabled NOT reset
DNS1 and DNS2 Configuration
for IPv4
(dhcp) NOT reset
DNS1 and DNS2 Configuration
for IPv6
Disabled NOT reset
Network Access Services
Primary Network Interface (eth0) Enabled NOT reset
Secondary Network Interface
(eth1)
Disabled NOT reset
SSH Disabled NOT reset
HTTPS Disabled NOT reset
Self Signed SSL Certificate No file NOT reset
Internal IP (eth2)
Internal network IP IP Range defined with Operator Panel NOT reset
Managing 67

Dell EMC ML3 Specifications

General

Number of Drives	1
Category	Tape Library
Drive Technology	LTO
Humidity	20% to 80% (non-condensing)
Drive Type	LTO Ultrium
Maximum Capacity	15 TB (compressed)
Interface	6Gb/s SAS
Max Data Transfer Rate	up to 750 MB/s (with compression)
Operating Temperature	10°C to 35°C
Non-operating Temperature	-40°F to 140°F (-40°C to 60°C)