Dell S2815dn - Tray Management

Dell™ Printer Configuration Web Tool 179
Tray Management
Use the Tray Management menu to set the paper size and type of paper loaded in tray1 and the optional 550-sheet
feeder.
Va lu e s:
MPF Mode Sets the MPF Mode.
MPF Paper Size
*1
Sets the size of paper loaded in the MPF.
MPF Paper Type
*1
Sets the type of paper loaded in the MPF.
MPF Custom Paper
Size - Y
*1
Sets the length of custom size paper loaded in the MPF.
MPF Custom Paper
Size - X
*1
Sets the width of custom size paper loaded in the MPF.
MPF Display Tray
Prompt
*1
Sets whether to display a popup message that prompts the user to set the paper size and type when
the paper is loaded in the MPF.
Tray 1 Paper Size Sets the size of paper loaded in tray1.
Tray 1 Paper Type Sets the type of paper loaded in tray1.
Tray 1 Custom Paper
Size - Y
Sets the length of custom size paper loaded in tray1.
Tray 1 Custom Paper
Size - X
Sets the width of custom size paper loaded in tray1.
Tray 1 Display Tray
Prompt
Sets whether to display a popup message that prompts the user to set the paper size and type when
the paper is loaded in tray1.
Tray 2 Paper Size
*2
Sets the size of paper loaded in the optional 550-sheet feeder.
Tray 2 Paper Type
*2
Sets the type of paper loaded in the optional 550-sheet feeder.
Tray 2 Custom Paper
Size - Y
*2
Sets the length of custom size paper loaded in the optional 550-sheet feeder.
Tray 2 Custom Paper
Size - X
*2
Sets the width of custom size paper loaded in the optional 550-sheet feeder.
Tray 2 Display Tray
Prompt
*2
Sets whether to display a popup message that prompts the user to set the paper size and type when
the paper is loaded in the optional 550-sheet feeder.
1st Priority Sets the paper source to be used as the first priority.
2nd Priority Sets the paper source to be used as the second priority.
3rd Priority
*2
Sets the paper source to be used as the third priority.
*1
This item is available only when Use Panel Settings is selected in MPF Mode.
*2
This item is available only when the optional 550-sheet feeder is installed.