Dell S2815dn - Verifying the Settings Using Ping Command; Verifying the Settings Using System Settings Report

82 Setting the IP Address
3 Ta p t h e Network tab.
4 Verify the IP address displayed in IP(v4) Address .
Verifying the Settings Using System Settings Report
1 Print the system settings report.
For details about how to print a system settings report, see "Report / List."
2 Verify the correct IP address, subnet mask, and gateway address are listed in the system settings report under
Network (Wired) or Network (Wireless) .
If the IP address shows
0.0.0.0 (the factory default), an IP address has not been assigned. To assign one for your
printer, see "Assigning an IP Address."
Verifying the Settings Using Ping Command
Send a ping request to the printer and verify that it responds. For example, at a command prompt on a network
computer, type "ping" followed by the new IP address (for example, 192.0.2.0):
ping 192.0.2.0
If the printer is active on the network, you will receive a reply.