Chapter 3 Start Up|VFD-M-D Series
Revision Jan. 2007, MDE2, SW V1.05 3-3
NOTE
1. Stop running immediately if any fault occurs and refer to the troubleshooting quide for solving
the problem.
2. Do NOT touch output terminals U, V, W when power is still applied to L1/R, L2/S, L3/T even
when the AC motor drive has stopped. The DC-link capacitors may still be charged to
hazardous voltage levels, even if the power has been turned off.
3. To avoid damage to components, do not touch them or the circuit boards with metal objects or
your bare hands.
To Next Page
Loading...
