108
7
Press the ENTER button to return to the Trigger Out screen.
Use the same procedure to make the settings for Trigger Out 2, 3, 4.
(Main unit) (Remote control unit)
6
If “MAIN” was selected at step 4, the trigger out
jack’s output setting can also be made for the
various surround modes.
¥
¥¥ŕʼnřÃŅŐōŃŚÃŅŕŔ
¥¥¥ńŊŏņŎł¥¥¥¥¥¥¥¥«
¥¥¥ŎŖŔŊń¥¥¥¥¥¥¥¥¥«
¥¥¥ňłŎņ¥¥¥¥¥¥¥¥¥¥«
¥¥ŘŊŅņ¥Ŕńœņņŏ¥¥¥¥«
¥¥Łńʼn¥ŔŕņœņŐ¥¥¥¥¥«¥
¥¥ŅŔő¥ŔŊŎŖōłŕŊŐŏ¥«
¥¥ŎŖōŕŊ¥ńʼn¥ŎŐŅņ¥¥«
¥¥ŅŊœņńŕÃŔŕņœņŐ¥¥«
10
10
10
10
10
10
10
10
DRCT/ST : ON
*Trigger Out 1
q Select the surround mode. w Select “ON” or “OFF”.
ON : If that surround mode is selected when an input source set to “ON” is selected, the power supplied from the trigger out jack turns
on.
OFF : If that surround mode is selected when an input source set to “ON” is selected, the power supplied from the trigger out jack turns
off.
(Main unit) (Remote control unit)
(Main unit) (Remote control unit)
8
Select “Exit” then press the ENTER button at the
Trigger Out screen.
The Option Setup Menu reappears.
¥
¥¥¥ŕŭŤŢŢŠŭ¥ŐŰů¥Ĺ
¥¥¥ŕŭŤŢŢŠŭ¥ŐŰů¥ĺ
¥¥¥ŕŭŤŢŢŠŭ¥ŐŰů¥Ļ
¥¥¥ŕŭŤŢŢŠŭ¥ŐŰů¥ļ
¥
¥¥¥ŅŠšŜŰŧů
¥
¥¥¥ņųŤů
¥¥Ŀáļ©ŕŭŤŢŢŠŭ¥ŐŰů
;G U
(Main unit)
(Remote control unit)
(Main unit)
(Remote control unit)
If “Yes” is selected for “Default”, the setting are
automatically reset to the default values.