Denon AVR-5805 - Memory and Call-Out Functions of Zone2 (USER MODE Function)

163
Memory and call-out functions of Zone2 (USER MODE function)
• The AVR-5805 is equipped with a function for storing the input source, auto surround mode and input mode settings selected for the main zone
and Zone2 in the memory so they can be used whenever desired.
• For Zone2, three patterns of settings can be stored in the memory using the USER MODE 1, 2 and 3 buttons on the Remote control unit.
• See page 146 for a description of the Main zone’s “USER MODE” function.
2 Storing the settings in the memory
1
Set the following to the desired status:
q Zone2 input source
w Zone2 auto surround mode
e Zone2 input mode
3
Press and hold the USER MODE
button at which you want to store the
settings.
NOTE:
• When the setup lock function is activated, memory operation of
the USER MODE button can not be performed.
2 Calling the settings out
2
Select the USER MODE button at
which the settings you want to call out
have been stored.
2
Select the ZONE2 mode using the
AMP/Z2 button.
(Remote control unit)
1
Select the ZONE2 mode using the
AMP/Z2 button.
(Remote control unit)
2
3
3
1
2
2
(Remote control unit)
(Remote control unit)
¥¥ŖŔņœ¥Ĺ¥ŎņŎŐœŚ
¥¥¥¥¥ŔŕņœņŐ
¥¥¥¥¥ŅŗŅ
¥ŖŔņœ¥Ĺ¥Ŕņōņńŕ
#761
+PRWV
/QFG