31
2 Measurement flow
I. Connect the microphone to be used for the auto setup procedure.
Please place the measuring microphone at ear height at the main listening
position.
III.Preliminary measurement items
q Measuring the background noise (noise in the room)
w Determining whether or not speakers are connected (speaker detection)
e Checking the polarities of the speakers
NOTE:
• A moderately loud test tone is output during
the measurement. Please consider this should
you be planning night time measurements, and
consider not allowing small children into the
listening time.
II. Extra Setup
q Channel Setup
w Power Amp Assign
By default, the speaker system
setting is set to 9.1 channels.
Please set under “Extra Setup”,
only when you want to change
this arrangement.
III.Check the results of the speaker detection.
IV.Speaker system measurement items
q Speaker Configuration : This sets the speaker bass reproduction ability.
w Delay Time : This sets the optimum delay time from each speaker corresponding to the listening position.
e Channel Level : This sets the volume that is output from each speaker.
r Crossover Frequency : This set the frequency (Hz) below which the bass sound of the various speakers is to be output from
the subwoofer.
t Room EQ : This sets the frequency response of each speaker.
(Main (1st) listening position)
Continue measuring ?
Select “OK Next” and put the
microphone at next point.
Quit measuring ?
Select “Calculate”.
V. Check the results of the speaker system measurements.
V. Store the measurement results in the memory.
Move the microphone to the 2nd
to 8th listening positions and
repeat the measurement.
¨
«
«
ª
To Next Page
Loading...
Need help?
General
