74
4-4. Setting the 3D Y/C Separation
• This setting sets the action detection sensitivity of the 3-dimensional Y/C separation at the time of the video signal up-conversion to S-Video.
1
¥¥¥
¥¥Ĺ©ńŪŨūŪũŠũů¥Ŋũ¥łŮŮŤŢũ
¥¥ĺ©ŗŤşŠŪ¥ńŪũűŠŭů¥ŎŪşŠ
¥¥Ļ©ŗŤşŠŪ¥ŔŞŜŧŠŭ
¥¥ļ©ĻŅ¥ŚÃń¥ŔŠūŜŭŜůŤŪũ
¥¥Ľ©ʼnŅŎŊÃŅŗŊ¥Ŋũ¥łŮŮŤŢũ
¥¥ľ©łŰşŤŪ¥ŅŠŧŜŴ
¥¥Ŀ©Őũ¥ŔŞŭŠŠũ¥ŅŤŮūŧŜŴ
¥¥ņųŤů
¥ļ©ŗŤşŠŪ¥ŔŠůŰū
Select “3D Y/C Separation” at the Video Setup
Menu.
2
Display the 3D Y/C Separation screen.
¥
¥
¥¥ŎŪůŤŪũ¥ŅŠůŠŞůŤŪũ«¥ŎŊŅ
¥
¥
¥
¥
¥
¥
¥ļáļ©ĻŅ¥ŚÃń¥ŔŠūŜŭŜůŤŪũ
MotionDet: MID
*3D Y/C Sep.
(Main unit) (Remote control unit)
(Main unit) (Remote control unit)
3
Select the setting.
HIGH : This sets the action detection sensitivity to a high level. It suits video with fast action.
MID : This is the standard setting. Usually, this setting is recommended.
LOW : This sets the action detection sensitivity to a low level. It suits video with little action,
such as still images, etc.
(Main unit) (Remote control unit)
NOTES:
• When the component video input signal is a resolution other than 480i/576i, this setting is invalid and the input video is output without
change.
• The setting of the aspect ratio is valid when the resolution has been set to 1080i or 720p. When the video is output at another resolution,
please set the aspect ratio at the TV side.
• When the composite input signal or S-video input signal is in PAL format or when the component input signal is in 576i format, the video
signal is output with a resolution of 576p, even if the resolution is set at 1080i or 720p.
4
Enter the setting.
The Video Setup Menu reappears.
(Main unit) (Remote control unit)
5
Enter the setting.
The Video Setup Menu reappears.
(Main unit) (Remote control unit)
To Next Page
Loading...
Need help?
General
