112
6
Select “Exit” and press the ENTER button to finalize the setting and exit the Option Setup mode.
When the setup lock function is activated, the settings listed below cannot be changed, and
“Setup Locked” is displayed when related buttons are operated.
• System setup settings
• Surround parameter settings
• Tone control settings
• Channel level settings (including test tones)
• RoomEQ
To unlock, press the System Setup button again and
display the Setup Lock screen, then select “OFF”
and press the ENTER button.
(Main unit)
(Remote control unit)
(Main unit)
(Remote control unit)
¥¥¥
¥¥Ĺ©ńţŜũũŠŧ¥ŔŠůŰū
¥¥ĺ©őŪŲŠŭ¥łŨū¥łŮŮŤŢũ
¥¥Ļ©ŗŪŧŰŨŠ¥ńŪũůŭŪŧ
¥¥ļ©ŕŭŤŢŢŠŭ¥ŐŰů
¥¥Ľ©łń¥ŐŰůŧŠů¥łŮŮŤŢũ
¥¥ľ©ŔŠůŰū¥ŎŠŨŪŭŴÃōŪŞŦ
¥
¥¥ņųŤů
¥Ŀ©ŐūůŤŪũ¥ŔŠůŰū
System setup is complete. Once these settings are made, there is no need to change them unless different AV components are
connected or the speakers are repositioned.
After completing system setup
This button can be pressed at any time during the system setup process to complete the process.
1
Press the SYSTEM SETUP button at the System Setup Menu, or select “Exit” and press the
ENTER button.
The changed settings are entered and the on-screen display turns off.
(Main unit) (Remote control unit)
(Main unit)
(Remote control unit)
(Main unit)
(Remote control unit)
¥
¥¥Ĺ©łŰůŪ¥ŔŠůŰūÃœŪŪŨ¥ņŒ
¥¥ĺ©ŔūŠŜŦŠŭ¥ŔŠůŰū
¥¥Ļ©łŰşŤŪ¥ŊũūŰů¥ŔŠůŰū
¥¥ļ©ŗŤşŠŪ¥ŔŠůŰū
¥¥Ľ©łşűŜũŞŠş¥őŧŜŴŝŜŞŦ
¥¥ľ©śŪũŠ¥ŔŠůŰū
¥¥Ŀ©ŐūůŤŪũ¥ŔŠůŰū
¥¥ņųŤů
¥¥ŔŴŮůŠŨ¥ŔŠůŰū¥ŎŠũŰ
2 On-screen display for component video outputs
• When viewing component video signals via the AVR-5805, the on-screen display is only displayed on the monitor when the “System Setup”
and “Surround Parameter” operations are performed and when the Remote control unit’s ON SCREEN button is operated.
• When only component video signals are input to the AVR-5805 or when “Component” is selected at the “Video Convert Mode settings”, the
characters of the on-screen display are not displayed over the picture.
To Next Page
Loading...
