87
6-2. Setting the low frequency distribution for Zone2
• Set the subwoofer mode according to the speaker systems used in Zone2.
1
¥¥¥
¥¥Ĺ©ŔūŠŜŦŠŭ¥ńŪũšŤŢ©
¥¥ĺ©ŔŰŝŲŪŪšŠŭ¥ŎŪşŠ
¥¥Ļ©ŅŠŧŜŴ¥ŕŤŨŠ
¥¥ļ©ńţŜũũŠŧ¥ōŠűŠŧ
¥¥Ľ©ńŭŪŮŮŪűŠŭ¥ŇŭŠŬŰŠũŞŴ
¥¥ľ©ŗŤşŠŪ¥ŔŠůŰū
¥¥Ŀ©śŪũŠĻÃļ¥ŕŪũŠÃńţ¥ōŠű©
¥¥ņųŤů
¥ľ©śŪũŠ¥ŔŠůŰū
Select “Subwoofer Mode” at the Zone Setup Menu.
2
Display the Subwoofer Mode screen.
¥¥ľáĺ©ŔŰŝŲŪŪšŠŭ¥ŎŪşŠ
¥
¥
¥
¥¥¥¥¥ōŇņ¥¥¥«¥¥¥ōŇņ
¥¥¥¥¥¥¥¥¥¥¥¥¥¥àŎŜŤũ
¥
¥
¥
¥
<QPG
(Main unit) (Remote control unit)
(Main unit) (Remote control unit)
3
Select the setting.
LFE :
For any channel(s) that are set to LARGE, low frequencies in that channel’s corresponding
source are directed to that loudspeaker only. Low frequencies that are directed to the
subwoofer(s) are from the program source LFE channel, and from other channels where the
speakers are set to SMALL.
LFE + Main :
Low frequencies from speaker channels that have been set to LARGE are reproduced from
those speakers as well as from the subwoofer(s). Depending upon the characteristics of the
LARGE main speakers, this mode may provide a more even low frequency response
throughout the listening room.
(Main unit) (Remote control unit)
4
Enter the setting.
The Zone Setup Menu reappears.
(Main unit) (Remote control unit)
NOTE:
• The subwoofer mode setting is only valid when “Large” is set for the Zone2 front speakers and “Yes” is set for the subwoofer in the
“6-1. Speaker Configuration” settings. (See page 86)
To Next Page
Loading...
Need help?
General
