EasyManuals Logo

Denon AVR-5805 User Manual

Denon AVR-5805
208 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #120 background imageLoading...
Page #120 background image
120
System call
(1) System call buttons
Up to 12 signals each can be stored at
the “CALL1” ~ “CALL6” buttons.
The System Call function can be used
in the AMP, ZONE2, ZONE3 and
ZONE4 modes.
(2) Storing system call signals
1
2
5
Press the power ON button and the OFF button at the same
time.
Press the “3” button to select
system call setting.
The mode can be switched by
pressing a mode button.
RC-995
3, 5
2, 6, 8
3, 7
1
8
The accessorious Remote control unit is equipped with “system call” function allowing a series of remote control signals to be transmitted by
pressing a single button.
This function can be used for example to turn on the amplifier’s power, select the input source, turn on the monitor TV’s power, turn on the source
component’s power and set the source to the play mode, all at the touch of a single button.
3
4
Press the button you want to register.
6
Repeat steps 4 and 5 to register the desired buttons.
Up to 12 signals each can be stored at the CALL1~CALL6.
7
Press the ENTER button after the button registration is
completed. There will be a changeover to the System Call
registration screen.
Press the Mode button for the component you want to
register at the system call button, then press the ENTER
button.
8
Press buttons from “CALL 1” to
“CALL 6” to register the System
Call.
“OK” is displayed and the set
returns to the normal operating
mode.
CH SEL
ENTER

Table of Contents

Other manuals for Denon AVR-5805

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-5805 and is the answer not in the manual?

Denon AVR-5805 Specifications

General IconGeneral
BrandDenon
ModelAVR-5805
CategoryReceiver
LanguageEnglish

Related product manuals