Denon AVR-5805 - Procedure for Copying the Flat Correction Curve

84
2 Procedure for copying the “Flat” correction curve set at “Auto Setup”, then using the graphic equalizer to adjust
manually
NOTE: If the “Auto Setup” procedure has not been performed, this item is not displayed.
1
Select “Base Curve Copy”.
Ľáļ©ŎŜũŰŜŧ¥ņŒ
¥¥ŅŠšŜŰŧů¥¥ŚŠŮ
¥¥ŃŜŮŠ¥ńŰŭűŠ¥ńŪūŴ
¥¥łşťŰŮů¥ńʼn¥¥ōÃœ¥ńʼn
¥¥ņųŤů
¥
¥
¥
¥
¥
BaseCurve Copy
*Manual EQ
CH SEL
ENTER
(Main unit) (Remote control unit)
2
The Base Curve Select screen appears when the
Cursor left button is pressed.
¥¥Ľáļ©ŎŜũŰŜŧ¥ņŒ
¥¥¥¥ńŰŭűŠ«¥áŇŧŜůá
¥¥¥ŃŜŮŠ¥ńŰŭűŠ¥ńŪūŴ
¥¥¥¥¥¥¥«
;G U
0Q
Copy?: No
*Base Curve
CH SEL
ENTER
(Main unit) (Remote control unit)
3
Select “Base Curve Copy?”, then press the Cursor
left button to select “Yes”.
¥¥Ľáļ©ŎŜũŰŜŧ¥ņŒ
¥¥¥ŃŜŮŠ¥ńŰŭűŠ¥ńŪūŴ
¥¥¥¥¥¥¥«
¥¥¥¥ńŰŭűŠ«¥áŇŧŜůá
;G U
0Q
Copy?: Yes
*Base Curve
4
Enter the setting.
The Manual EQ screen reappears.
The type of the copied correction curve is displayed
in the upper right of this screen.
Ľáļ©ŎŜũŰŜŧ¥ņŒ¥¥¥¥¥áŇŧŜůá
¥¥ŅŠšŜŰŧů¥¥ŚŠŮ
¥¥ŃŜŮŠ¥ńŰŭűŠ¥ńŪūŴ
¥¥łşťŰŮů¥ńʼn¥¥ōÃœ¥ńʼn
¥¥ņųŤů
(Main unit)
CH SEL
ENTER
(Remote control unit)
CH SEL
ENTER
(Main unit)
(Remote control unit)
CH SEL
ENTER
(Main unit) (Remote control unit)