119
Learning function
If an AV component is not a DENON product, or if it cannot be operated via codes provided in the AVR-5805 remote control's internal preset
memory, or if its codes cannot be successfully learned by the AVR-5805 remote control, then you should use the remote control that was supplied
with that AV component to operate the component.
1
Press the power ON button and the OFF button
simultaneously.
2
Press the “2” button to select
Learning setup.
3
Press the Mode button for the component you want to
learned, then press the ENTER button.
Learning is not possible for the AMP, ZONE2, ZONE3 and
ZONE4 modes.
4
Buttons that allow learning will light. Press the button that you
wish to be learned. The display will go off and the unit will
enter the learning standby mode.
5
Point the Remote control units directly at each other and
press and hold in the button on the other Remote control unit
which you want to “learn”.
6
“OK” appears on the Remote control unit’s display and
learning is completed.
• Other keys can be “learned” by repeating steps 5 to 6.
• “FAIL” appears on the Remote control unit’s display,
repeating steps 4 to 6.
7
The mode can be switched by
pressing a mode selector button.
The “Buttons that allow learning”
display reappears and the learning
standby mode is set.
Other remote
control unit
8
To cancel the learning mode, press the power ON button and
the OFF button simultaneously again.
• To cancel, press the power ON button
and the OFF button simultaneously.