6. Other Field Service Ver. 1.0 Apr. 2005
52
ineo 161
ineo 210
Maintenance
12. Secure the front and rear cable pul-
leys to the shaft using one screw
each.
NOTE
• The direction in which the screw is
installed differs between the front
and rear. Note the correct direction.
13. Wind the lower cable of wire pulley 1
around pulley A.
14. Wind the cable from pulley A around
pulley B.
NOTE
• Wind the cable around the outer
groove in pulley B.
15. Pass the cable from pulley B into the
hole in the IR frame.
4035D118AA
4035D119AA
Pulley A
4035D120AA
Pulley A
Pulley B
4035D121AA
To Next Page
Loading...
