Develop ineo 161 - 10.3 Setting in the Service Mode; Services Choice

Field Service Ver. 1.0 Apr. 2005 10. Service Mode
83
ineo 161 ineo 210
Adjustment / Setting
10.3 Setting in the Service Mode
10.3.1 SERVICE’S CHOICE
• SERVICE’S CHOICE is used to make the various service settings.
A. SHIPMENT DESTINATION
B. MAINTENANCE COUNTER
C. IU LIFE STOP MODE
Purpose/Use To select the display of the fixed zoom ratios and paper sizes according to the applica-
ble marketing area.
Setting/
Procedure
• The default setting is “METRIC.”
“METRIC”
INCH
JAPAN
CHINA
L. AMERICA (METRIC)
L. AMERICA (INCH)
Purpose/Use To enter an appropriate counter value (0 to 999999) as the tentative maintenance time.
Specify the setting on maintenance counter to “1” or “2”: If the maintenance life is
reached, the maintenance call (M1) or Tech. Rep. call [Call Service (M1)] will appear.
Setting/
Procedure
• The default setting is “0.”
“0” : Not counted
1 : Counted (The maintenance call display is given when the counter reaches 0.)
2 : Counted (The Tech. Rep. call display is given and the initiation of any new copy
cycle is inhibited when the counter reaches 0.)
✽ When “1” or “2” is selected, a screen will then appear to allow the counter value to be
entered.
NOTE
• The counter value is decremented until it reaches -999999 even after it has
counted 0.
Purpose/Use When the Supplies Life Count. reaches the life value, the IU life will be detected. The
mode when the IU life is reached, is specified by this setting.
Setting/
Procedure
• The default setting is “CONTINUOUS.”
“CONTINUOUS”: Enables copying. Maintenance call display is given.
STOP : Disables copying. Tech. Rep. call display is given and the initiation
of any new copy cycle is inhibited.
NOTE
• The counter value is decremented until it reaches -999999 even after it has
counted 0. In this case, however, no image quality is guaranteed.