Develop ineo 161 - 10 Service Mode; 10.1 Service Mode Function Setting Procedure; Changing the Setting Value in Service Mode Functions; Exiting

Field Service Ver. 1.0 Apr. 2005 10. Service Mode
79
ineo 161 ineo 210
Adjustment / Setting
10. Service Mode
• The Service mode is used to check, set, adjust, or register the various service functions.
10.1 Service Mode function setting procedure
NOTE
• Care must be used to ensure that only the personnel who are involved in service
jobs know the procedure to enter the Service mode.
10.1.1 Procedure
1. Press the Utility key.
2. Press the following keys in this order.
3. Stop → 0 → 0 → Stop → 0 → 1
4. The Service mode menu screen will appear.
10.1.2 Exiting
• Press the Panel Reset key as many times as it is required to display the initial screen.
10.1.3 Changing the Setting Value in Service Mode Functions
1. Select the desired item using [ ▲ / ▼ ] key.
2. Select the setting value using [ ▲ / ▼ ] key, [ < / > ] key, or the 10-Key Pad.
3. Validate the selection by pressing the [Yes] key.
4. To go back to previous screen, press the [No] key.