8. Utility Mode Field Service Ver. 1.0 Apr. 2005
74
ineo 161
ineo 210
Adjustment / Setting
E. BINDING POS.
F. MARGIN SETTING
G. ERASE SETTING
H. SMALL ORIGINAL
8.3.6 COPY SETTING 2
• COPY SETTING 2 is used to set the default values for different copy functions.
A. MIXED ORIGINAL
B. COPY PRIORITY
Purpose/Use To set the first page to be scanned when copies are made from a book, whether it is on
the left or on the right.
Setting/
Procedure
LEFT RIGHT
Purpose/Use To set the file margin width when making copies with a file margin.
Setting/
Procedure
• The default setting is “10 mm.”
Setting range: 0 to 20 mm
Purpose/Use To set the erase width when making erase copies.
Setting/
Procedure
• The default setting is “LEFT” and “10 mm.”
<Step>
1. Select the erase position.
“LEFT” UPPER FRAME
2. Set the erase width.
Setting range: 5 to 20 mm
Purpose/Use To set whether to enable or disable copying when an original of a size smaller than the
detectable one is loaded in the Auto Paper mode.
Setting/
Procedure
• The default setting is “DISABLE.”
“DISABLE” ENABLE
Purpose/Use To set whether or not to select the Mixed Original mode when the Power Switch is
turned ON or Panel Reset key is pressed.
Setting/
Procedure
• The default setting is “OFF.”
ON “OFF”
Purpose/Use To set the priority mode, either Auto Paper, Auto Size, or Manual, selected when the
Power Switch is turned ON or Panel Reset key is pressed.
Setting/
Procedure
• The default setting is “APS.”
“APS” AS MANUAL
To Next Page
Loading...
