Field Service Ver. 1.0 Apr. 2005 8. Utility Mode
71
ineo 161
ineo 210
Adjustment / Setting
B. TRAY1 PAPER
C. PAPER TYPE
* appears only when the AD-504 (ineo 210 only) is installed.
8.3.3 USER MANAGEMENT
A. DRUM DEHUMIDIFY
B. TONER REPLENISHER
Purpose/Use To set the type and size of the paper loaded in Paper Feed Tray/1.
Setting/
Procedure
• The default setting is “PLAIN” and “AUTO.”
<Step>
1. Select the type of paper.
“PLAIN” OHP CARD ENVELOP
2. Set the paper size.
“AUTO”
SIZE INPUT
Setting range: 140 to 432 mm (X)
90 to 297 mm (Y)
Purpose/Use To set the type of paper for the paper source.
Setting/
Procedure
• The default setting is “PLAIN.”
<Step>
1. Select the paper source.
TRAY1 TRAY2 BYPASS
2. Select the type of paper.
“PLAIN” RECYCLE SPECIAL 1-SIDE*
Purpose/Use To run a drum dry sequence.
✽ The drum dry sequence is run when an image problem occurs due to condensation
formed on the surface of the PC Drum as a result of a sudden change in temperature
or an increased humidity.
Setting/
Procedure
<Step>
1. Select “DRUM DEHUMIDIFY” and press the [Yes] key.
2. The drum dry sequence is automatically terminated after the lapse of a predeter-
mined period of time and the initial screen reappears.
Purpose/Use To forcedly replenish the supply of toner when ID drops as a result of a reduced T/C
ratio after a large number of copies have been made from an original having a high
image density, thereby achieving the set T/C level.
Setting/
Procedure
• When “TONER REPLENISHER” is executed, the copier first detects the current toner
density. If it is found that the density is lower than the reference value, supply of toner
is replenished and then toner is agitated. If the density is found to be higher than the
reference value, the copier simply agitates toner to complete the sequence.
<Step>
1. Select “TONER REPLENISHER” and press the [Yes] key.
2. The toner replenisher sequence is automatically terminated after a given period of
time or when the specified toner density is recovered. Then, the initial screen reap-
pears.
To Next Page
Loading...
