Field Service Ver. 1.0 Apr. 2005 10. Service Mode
85
ineo 161
ineo 210
Adjustment / Setting
For ineo 210
G. FUSER TEMP. Ad (THICK)
<Temperature table for adjusting fusing temperature for special paper>
For ineo 161
For ineo 210
Setting value Paper width
Mode selected in Service’s Choice
Mode 1 Mode 3
Fusing Heater Lamp temperature (main/sub)
2
221 mm or more
200 °C
220 mm or less
1
221 mm or more
190 °C
220 mm or less
0 (default value)
221 mm or more
180 °C
220 mm or less
-1
221 mm or more
170 °C
220 mm or less
Purpose/Use To set the fusing temperature when thick paper is used.
✽ When fusing failure occurs
Setting/
Procedure
• The default setting is “0.”
Setting range: -1 to +1
Setting value
Paper width
Mode selected in Service’s Choice
Mode 1 Mode 3
CD Fusing Heater Lamp temperature
1
251 mm or more 210 °C 200 °C
250 mm or less 210 °C 200 °C
0 (default value)
251 mm or more 210 °C 190 °C
250 mm or less 200 °C 190 °C
-1
251 mm or more 200 °C 180 °C
250 mm or less 190 °C 180 °C
Setting value
Mode selected in Service’s Choice
Mode 1 Mode 3
Fusing Heater Lamp temperature (main/sub)
1 210 °C
0 (default value) 200 °C
-1 190 °C
To Next Page
Loading...
