2
INTRODUCTION
14 AXH1157-UK (ENG) L3500 L4700 F7000 [FPT S3A]
2.1 - Manual structure
This manual is an integral part of the official
documentation of the Vehicle, Equipment and Tool. It
must be carefully stored and be available to the
managers, the users and personnel in charge of
maintenance.
2.2 - Purpose and content
This manual is an integral part of the official
documentation and is aimed at supplying the
Operator with all the information required concerning
technical aspects, operation and safety during the
entire lifespan of the vehicle or equipment.
ATTENTION
This manual should be read carefully before the
first use or before maintenance.
NOTE
If in doubt on the correct understanding of the
instructions, contact the Manufacturer for
clarifications.
2.3 - Preservation
The instruction manual must be kept near the
equipment available to the Users (in the cab or on the
equipment where set up) inside a dedicated envelope,
protected from liquids and anything that might make
it illegible.
If the manual becomes creased and/or be, even
partially, damaged or illegible or in case of loss of the
manual, it must be replaced immediately by
contacting the
Dieci Technical Assistance Service
,
giving the details of the manual found on the first
page of the manual.
2.4 - Recipients
This manual is addressed to the following persons:
• Operator : instructed person, trained with specific
theoretical-practical course concerning use of the
vehicle or equipment
• Generic maintenance technician : trained and
educated person to perform routine maintenance
interventions with basic mechanical, electrical
and hydraulic knowledge
• Specialized maintenance technician : trained
and educated person to perform routine and
extraordinary maintenance interventions with in-
depth and specific mechanical, electrical and
hydraulic knowledge, normally sent or authorized
by
DIECI s.r.l.
or the dealer.
ATTENTION
The users must not carry out operations reserved
for maintenance technicians or qualified
technicians. The Manufacturer is not liable for
damage deriving from the non-compliance with
this prohibition.
2.4.1 - Training
This manual gives the users all technical data on the
vehicle or on the equipment, the presence and type of
control and safety devices and the presence and
meaning of the safety stickers and plates.
All vehicle or equipment users must have all necessary
information, training and education in relation to the
correct use conditions of the means and foreseeable
anomalous risks.
The information, training and educating must be
implemented upon introduction of new work
equipment and for each work equipment available to
users.
NOTE
Ensure to respect the current laws and Standards
in the selling country of the vehicle with regard to
information, training and educating of personnel
to use the vehicle and its equipment.
The employer is obliged to inform personnel on the
following topics related to safety during use:
• Risk of injury
• Vehicle and equipment safety devices set up for
operator safety
• Individual safety devices set up for operator
safety
• General accident-prevention rules and/or
foreseen by international directives
• Accident-prevention rules of Legislation of the
Country where the vehicle or the equipment is
intended for use
The operator, before starting the work, must know the
characteristics of the vehicle and equipment and must
have fully read this Use and Maintenance Manual.
To Next Page
Loading...