SAFETY REGULATIONS 4
AXH1157-UK (ENG) L3500 L4700 F7000 [FPT S3A] 43
• If the engine does not start within 5 seconds, try
again at regular 15 second intervals to prevent
overloading the starter motor.
4.12.4 - Warm-up after starting-up
During the first few minutes of use, keep the speed
slow in order to warm up the engine and hydraulic oil.
WARNING
Serious damage can be caused to the
engine and the hydraulic system if the
engine reaches high rpm before the
operating oil temperature and pressure
levels are reached.
Let the engine run at 1100 - 1300 rpm for about 5
minutes so as to bring the engine oil to the
operating temperature, particularly, with outdoor
temperatures below 0 °C.
4.12.5 - Start-up at low
environmental temperatures
Consider the following warnings before starting-up at
low environmental temperatures and with a cold
engine:
• In order to prevent discharging the battery, do
not prolong each attempt to start-up by more
than 15 seconds; however, if the engine does not
seem to be starting-up, extend the time to a
maximum of 30 seconds.
• Wait at least one minute before trying to start-up
again.
• It is recommended to not exceed six start-up
attempts so as not to discharge the battery
excessively.
NOTE
It is recommended to use anti-freeze diesel at
environmental temperatures lower than 0°C, so
as to make sure the engine is optimally supplied,
without reducing performance.
4.12.6 - Causes of failed start-ups
Check the following if the engine does not start-up:
• The parking brake switch is pressed.
• The gear selection lever is in the neutral position.
• No emergency buttons are pressed.
After checking all the previous conditions, remove the
cause of failure to start and try the starting procedure
again.
NOTE
If the problem persists, contact a
Dieci
after-sales
center.
4.12.7 - Turn off the vehicle
It is recommended to perform the following before
switching the engine off:
1. Bring all the control levers to the idle position.
2. Bring the engine to low speed for a few seconds.
3. Turn the ignition key to position "0".
4.13 - Truck mixers safe
working procedures
For safe working procedures in the various working
conditions refer to the "Safety standards" chapter.
WARNING
All the products used for the production
of the mix must be handled with the
appropriate PPE.
Refer to their safety data sheets for additional
specific directions.
DANGER
Do not modify the structure and vehicle stability
in any way by trying to add counterweights,
whichever artifice is used.
• Reduce the speed as much as possible and brake
gently during handling operations.
• Avoid passing over unstable objects. Remove
dangerous, unstable objects instead of passing
over or around them. Also avoid holes or bumps.
Before turning, slow down as much as possible.
• Do not change direction abruptly or at high
speed.
• Remember that hydraulic steering is very
sensitive to steering wheel movements; steer
gradually and avoid sudden movements.
• Slow down before turning.
• Be careful to the lateral space. If possible, keep to
the center of the passage to avoid equipment or
personnel from obstructing your travel.
To Next Page
Loading...